BTF® Chlorinating Sanitizing Powder Lot of 25, .42 oz Packets

Description

- Powder sanitizer in a convenient pre-measured pouch.
- Clean rinsing – no residue left behind.
- EPA registered. FDA approved.
- For use in food service equipment and brewing.
- 25 x .42 Oz Packets of Sanitizing Powder.
SHAKE AND SOFT SERVE MACHINES CLEANING PROCEDURE
1. Remove mix from the machine.
2. Rinse the interior of the machine (cylinder, feed tubes, etc.) by activating the “Wash” cycle and drawing through 2 gallons (7.6 liters) of lukewarm water. Repeat the rinsing procedure until the water runs clear. Turn the machine to the “Off” position.
3. Prepare a cleaning solution of BTF by dissolving 1 packet in 2½ gallons (9.5 liters) of lukewarm water.
4. Clean machine interior by activating the “Wash” cycle and filling the cylinder and feed tubes with the cleaning solution. Turn the machine to the “Off” position. Brush clean the feed tube and inlet hole. With the cleaning solution in the cylinder, reactivate the “Wash” cycle and allow to remain on for five minutes.
5. Drain the solution from the machine. Turn machine to the “Off” position.
6. Remove and completely disassemble all machine parts (door, blades, pump, etc.).
7. Brush wash all disassembled parts in a suitable detergent in a clean sink.
8. Rinse thoroughly under clean running water.
9. Sanitize parts by immersing for at least 1 minute in a fresh BTF solution (1 packet dissolved in 2½ gallons/9.5 liters of lukewarm water).
10. Remove parts and allow to air dry.
11. Repeat the cleaning procedure for machines with two freezing cylinders.