-40%
Class A Power Amplifier Delay Soft Start Temperature Protection Board
$ 22.17
- Description
- Size Guide
Description
Class A Power Amplifier Delay Soft Start Temperature Protection BoardFeature:
For the CPI (A) or high-power amplifier, the maximum power of 2000W
Suppression amplifier boot transient inrush current, the power of the CPI (A) and high-power amplifier transformer, the load impedance ultra-low, and large power supply filter capacitance, resulting in the instantaneous current amplifier boot is too large, easy to damage the rectifier bridge and damage filter capacitor.
When the amplifier heat sink temperature exceeds 75 degrees, the board can immediately cut off power to the amplifier overheating. Until the heat sink temperature dropped to below 75 degrees, the amplifier before you can start, otherwise the amplifier can not be switched
Voltage: 110V or 220V (can select 110V or 220V, but the factory default is 220V)
(According to the size of the input voltage of the PP + input voltage: input 220V, that is, the PP and 220V pin welded together, pay attention to the PP can not be connected to 110V and 220V)
Dimension: 78mm × 87mm × 32 mm
Package
1pc Class A Power Amplifier Delay Soft Start Temperature Protection Board