Tektronix FG 5010 Programmable 20MHZ Function Generator, Tested

Description

Tektronix FG 5010 20MHz Programmable 20MHZ Function Generator
Used, Tested as Working. Shows some minimal marks from use.
I see no damage or missing elements EXCEPT:
on face at top right hand corner: I tried to remove very sticky residue from an unknown sticker by using rubbing alcohol which unfortunately also removed some painted lettering, "NOT ENTERED" now reads "NO."
This unit was taken off of a storage shelf and tested by an Electronics Engineer in July of 2019, was found to be "GOOD," and then replaced on a storage shelf until now.
As per attached Tektronix stickers:
Traceable Calibration Date: 06-OCT-2004
ID # 58124
Identification Number: FIRMWARE VER, 4
Serial Number: B052745
Reconditioned Equipment 001-0905-00D
FG 5010 Specifications, as per 1991 Tek Products catalogue:
0.002 Hz to 20 MHz
Up to 20V p-p From 50 Ohm
Sine, Square, Triangle, Pulse, and Ramp Waveforms
10 ns Rise/Fall
10% to 90% Variable Symmetry in 1% Steps
Trigger, Gate, Counted Burst
Phase Lock, With Autoscan
AM, FM, VCF
Waveform Complement  (Waveform Complement and +/- trigger slope allow interfacing circuits with the proper waveform phase, esp. important in pulse and digital applications. Waveform hold can freeze the output voltage of any 200 Hz or less waveform at its instantaneous value. With the output amplitude set to 0 V, the dc offset can be programmed to provide a dc voltage source of 0 to +/- 7.5 V in 10 mV steps.
All functions are fully programmable either from the front panel or over the GPIB.
Able to store up to 10 complete front panel settings
(FYI:  In 1991  Tektronix's FG5010 was offered for sale @ ,495.)
This FG 5010 measures approximately 11.5 x 5.25 x 5 inches and weighs approximately 7 pounds.
It will be shipped well padded in a good box.
Most items are shipped within 1 business day of receipt of payment.
Seller may adjust shipping fee if multiple items can be shipped in one box. If you would like to purchase more than 1 item, from any of my listings, Please put them in your Shopping Cart, Click on "Commit to Buy." Then Click on "Request an Invoice."  This will alert me to send to you an Invoice with the corrected postage. Then you can pay the Invoice. Thank You.